Installation of defence fencing company made from wood is not easy, but is also not complicated. If you have a basic amount of expertise, use a couple of household items, and put in some effort, it is possible to build a wooden fence that makes your neighbor jealous. The steps to installing a wood fence are outlined in this guide. The first thing you need is the list of necessary tools. If possible, have a large enough supply of material for your entire project.

This is a list of tools that you can use.

Boards & Posts

Power Saw

Post Hole Digger

Paint or Outdoor Stain

Steel Tape

Marking Pencil

Hatchet or Small Axe

Gravel vs Sand

Nails

Hand Saw

Hammer

Work Gloves

Level

Ready-Mix Concrete

Wood Chisel

Tamping Rod

Wood Preservative

Plumb bobble

It is possible that this is not an exhaustive list. This will depend on the complexity of your selected style. To level and dig holes for the fence, you can use an electric post-hole drill, cement mixer or small tractor. At any point, if you’re feeling uncomfortable, contact a professional fencing company. The fence adds value to the property and is long-lasting. Therefore, you should do it right from the beginning. For an 8-foot fence, the post should reach at least 10 feet.

Step 1. Rough Survey

First, you must locate and lay out your fence using string. As soon as you set up the boundary pins, it’s time to decide where you want the posts. Begin at corners, then place posts every six to eight feet in the center. Once you have determined the dimensions and locations of the obstacles, such as gates or fences that you might encounter, it is time to start building.

Next, you will need to set the posts.

It is better to build your fence from the back, if it’s your first project. Minor imperfections are easier to cover when farther away. The survey line should be walked to examine post placements for obstructions such as large rocks, trees, and stumps. Now, you can start to dig holes for the posts. The holes should be dug as the project progresses, otherwise the holes may fill with rainwater or even collapse. Do not allow the holes to be angled. According to the instructions from the manufacturer, mix the concrete with care. The post will require some wood scraps to hold it in place while the cement sets. On the first posts as well at the corners because you are going to center the entire line, this is very important. Pour two to three inches gravel in the hole’s bottom. It will help to drain the water and stop the post from getting rotten. Insert the post slowly into the opening, being careful not to cause the sides of the post to buckle. Attach braces along the opposing side and a plumb-bob in the middle of the pole, near its top. You must ensure that your post is perfectly square on each of its three axes. When the concrete pours, make sure the post stays in its position. Dig the next holes. To drain the water from the post, you want to make the concrete mound. Leave the concrete overnight to cure.

Step 3: Attaching rails & slats

As soon as the concrete sets, take off the bracing. Then check that the posts are positioned correctly. As you begin at a corner of the wall (preferably the front), attach the rails either with a bracket made from wood or metal, or with nails, screws or dowels. Be sure that you are checking your rails’ level, and where the posts should be placed throughout the entire process. Allow a two-inch gap under the rails or slats when positioning them. This will prevent moisture from entering and leading to decay.